Changes to 3. Feinstaub-Sensor Gehäuse Montage Introduction
Edit by Jochen Krapf —
Edit approved by Jochen Krapf
- Before
- After
- Unchanged
| Time Required Min |
30 minutes
|
| Time Required Max |
30 minutes
|
Guide Prerequisites
- #1 was empty but is now 1. Feinstaub-Sensor Gehäuse Basis (SDS011).
- #2 was empty but is now 2. Feinstaub-Sensor Gehäuse Tower (DHT22).
Tools
- 2k-Epoxy-Kleber x1 added.
Parts
- Gehäuse Basis und Tower x1 added.
- Feinstaubsensor SDS011 x1 added.
- PVC-Schlauch ??? x1 added.
- Blechschraube 3x7mm (oder 3x8mm) x3 added.
- Temperatur- und Feuchte-Sensor DHT22 x1 added.
- Blechschraube 2,2x5mm x1 added.
- Controller WeMos D1 mini (vorprogrammiert) x1 added.
- USB Micro Kabel flach (Länge nach Bedarf) x1 added.
- Kupferwinkel (Heizungsinstallation) 10mm 90° x1 added.
- Edelstahl-Geflecht 1mm Raster x1 added.
- Schrumpfschlauch 16mm Länge ca. 40mm x1 added.