Skip to main content

Site Navigation

Your Account

Choose Language


Time Estimate

Select a difficulty level for this entire task (including any prerequisite instructions). The difficulty ranking reflects the experience, physical dexterity, and risk involved.

Very easy

Does not require opening device.


Requires minimal disassembly and requires only basic tools like a Phillips or flat-head screwdriver.


Requires a fair amount of disassembly. This is a task that most people would not perform without instruction.


Requires significant disassembly and may require specialized tasks like soldering.

Very difficult

This task is considered quite challenging, may require specialized tasks like micro-soldering, and may risk damage to the device. If you can do this, people may call you MacGyver on occasion.

If your guide picks up where an existing guide leaves off, add the existing guide as a prerequisite to avoid having to write additional steps. Prerequisite guides will be displayed before this guide. Make sure that the prerequisite guides are in the correct order. You can change the prerequisite order by dragging the icons to the left of the guide's name.

  • 1 × 2k-Epoxy-Kleber
  • 1 × Gehäuse Basis und Tower
  • 1 × Feinstaubsensor SDS011
  • 1 × PVC-Schlauch ???
  • 3 × Blechschraube 3x7mm (oder 3x8mm)
  • 1 × Temperatur- und Feuchte-Sensor DHT22
  • 1 × Blechschraube 2,2x5mm
  • 1 × Controller WeMos D1 mini (vorprogrammiert)
  • 1 × USB Micro Kabel flach (Länge nach Bedarf)
  • 2 × Senkkopfschraube M4x50 (V2A)
  • 2 × Senkkopfschraube M4x80 (V2A)
  • 4 × Hutmutter (V2A)
  • 1 × Kupferwinkel (Heizungsinstallation) 10mm 90°
  • 1 × Edelstahl-Geflecht 1mm Raster
  • 1 × Schrumpfschlauch 16mm Länge ca. 40mm
Add New

Your contributions are licensed under the open source Creative Commons license.